Remote control has become a common accessory for your TV and the other consumer electronics. Sometimes TVs with support for Smart TV, the remote control responds poorly to keystrokes, TV control occurs with difficulty. People blame the bad developers. But the reason may be quite different.
Problems with the remote control uses Bluetooth
The remote control that allows you to send voice commands, move the cursor on the TV screen, usually interacts with the TV not the infrared signal and via bluetooth connection. For this functionality it is necessary to more advanced information transmission channel.
As components for television sets can be produced at different factories binding the remote control to the TV should occur at the stage of the last check of the TV at the factory, but sometimes, it is not done correctly, and many manufacturers offer even do it yourself.
The most basic in any remote control is powered, check or replace the batteries with new ones, with little TV remote control power management difficult.
If you have a remote control to the TV using bluetooth connection and poorly managed TV you must re-pair the remote control and the TV remotes majority after re-pairing is working properly.
Poor buttons are pressed
What to do if not work of the buttons that would change the channel it is necessary to strongly press the button, the reasons could be several:
- Erasing a conductive layer on the elastic button, these panels suffer low quality, normal remote control in the rubber buttons conductive material amended and such buttons work forever.
- There was dirt under the button contact, in this case it is necessary to disassemble the console and washed, it is best to simply soapy water or liquid to wipe the flat screens, it is necessary to dry after cleaning.
Who judged the remote control could be noted that under the most frequently used buttons are going to the substance of unknown origin similar to silicone. Most likely this is the allocation of substances made of silicone, which provides the elasticity of buttons, with more dirt is formed in those areas that are more commonly used, perhaps it affects the temperature of the human hand.
The remote does not work (infrared LED)
The remote control that operates in the infrared emission spectrum has a front LED, it can be closed with plastic, it looks something like this as shown in the photo below.
The remote control may fail, because there is nothing eternal, may fall or fail any electronic component. Check IR remote elementary. Infrared light is not visible to the human eye but it is perfectly react camera matrix.
Photo remote control in standby mode.
We take any camera or phone, turn on the camera we direct it to the infrared diode Hit the button on the screen we see flickering infrared diode, the remote control correctly, if not check the battery and if it does not help control should be repaired or buy a new remote control.
Below is a photo serviceable console mode button is pressed, the photo shows the glow of the LED.